3d Printed Glider Model

Additional Information

NEW UPDATE BELOW WITH NEW PARTS old: "Needs to be less than $25. Wings should be about 6 inches long. Fuselage should be around 8 inches long. Vertical stabilizer should be 1.5 inch tall. Horizontal stabilizers should be about 1 inch long. Link to all the parts: https://drive.google.com/drive/folders/1XF0yIXCoooKGP7MtFa7g12ZMXezdSM64?usp=sharing (Will need 1 of each part linked in the google drive document)."

DfAM Comments:

1. The larger the parts, the more expensive the fabrication. Can you scale down size? If so, please do and then update design files
2. Can you add at least 1x flat surface (even if minor) to aid and improve the 3D printability for Extrusion? Read more about design considerations here: https://bit.ly/you3dit-stanford-aa119n-2020

OLD: NEWER UPDATE! "New Update: (5/02/2020) Updated the design - shrunk down a bit. Added some flat surfaces. Exported in mm. New link with all the updated parts: https://drive.google.com/drive/folders/1s8UtdihfvoiYCDua8VOkvI1xN08KCQap?usp=sharing"

New Update: (5/03/2020) Updated the design even further (assuming you haven't printed yet). Added sockets to wings and pockets to fuselage to allow for better alignment and assembly upon arrival. Will not add to the stabilizers since they are already pretty thin will just stick to glue for those! New link with all the updated parts: https://drive.google.com/drive/folders/1xQxv3cOvbK8YgAm8ZBvQnzPwIt45PTrU?usp=sharing Thanks!

Share this project

𝕏